this fixes /hlds_run: line 321: 7373 Segmentation fault $HL_CMD
i had the same problem on CENT OS 6.3
note that centos 6.3 have enabled the SElinux , disabled it , reboot your system and use the hlds application again.
Code:
yum install nano -y
Code:
nano /etc/selinux/config
Code:
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - No SELinux policy is loaded.
SELINUX=disabled
# SELINUXTYPE= can take one of these two values:
# targeted - Only targeted network daemons are protected.
# strict - Full SELinux protection.
SELINUXTYPE=targeted